|
|
Posts: 626
Location: Madison, WI | I've read a lot about the mx sitting high on the trailer. I have a 7' high garage door, will this be an issue or is that fine? Any mx owners want to chime in? |
|
|
|
Posts: 106
| I have to tilt the motor down, but then I have about 2" of clearance.
I have the 150 Yamaha 4-stroke.
Edited by ranger618 2/28/2015 4:24 PM
|
|
|
|
Posts: 1638
Location: Minnesota | My garage door opening is 76 " high . I have to take the cover off the motor before putting it in the garage |
|
|
|
Posts: 269
Location: Oregon, WI | Dan
Just measured my door and it's 82". I do lower my motor almost all the way down and it measures 74" from top of motor to ground. Also measured windscreens and they were right around 75-76" as it sits but the the trailer jack is making it higher than it would be when hooked up to the truck. Would have to think it would be about the same as motor when hooked up. ??? Depending on the incline of driveway, That Could Change Things One Way Or another. In any event, it should fit.
Edited by V18 3/1/2015 1:22 PM
|
|
|
|
Posts: 626
Location: Madison, WI | Thanks guys. My door is 84" high so it should fit if trimmed down. Don - do you know the height of the motor when it's up in trailer position? |
|
|
|
Posts: 269
Location: Oregon, WI | Don't know exact height when up but do know for a fact it will hit top of my door. It doesn't hit by much. My door is 82 if yours is 84, don't take my word for it but it may JUST fit without trimming it down. |
|
|