|
|
Posts: 29
| Anyone know if the long telescopic TI rods up to 10'6" will fit in a Down East rod holder? I've seen it posted that they use a big reel seat and wondering if they fit well.
|
|
|
|
Posts: 1425
Location: St. Lawrence River | They may fit I'll check when I get home. I can't get my Toro S or Beast to fit due to the gear case though. |
|
|
|
Posts: 29
| That would be much appreciated. Wondering if I throw a trolling reel on one if it'll fit or not. Worried with the bigger reel seat it might be too snug to be practical. |
|
|
|
Posts: 1
| yes they do fit. i have the 10'6 telescopic and it fits in my holders. i filed down the trigger though so that it locks into the opening in the bottom. |
|
|
|
Posts: 4053
Location: Land of the Musky | Side note, I just made 50 TI 8' XH trolling rods. I made these 5 years ago but not too many.. Enough guys have asked me to make these again so I made 50. Sold 16 so far. I will not be putting these on my site. Normally they would be $165 MSRP +S/H but if anyone wants one they will be $150 with free S/H. I have the guys who wanted them taken care of now so on the chopping block they go
James
[email protected] |
|
|
|
| Tackle Industries - 7/26/2016 8:44 PM
Side note, I just made 50 TI 8' XH trolling rods. I made these 5 years ago but not too many.. Enough guys have asked me to make these again so I made 50. Sold 16 so far. I will not be putting these on my site. Normally they would be $165 MSRP +S/H but if anyone wants one they will be $150 with free S/H. I have the guys who wanted them taken care of now so on the chopping block they go
James
[email protected]
I have 2 of these and really like them. Great trolling rods for sure!!!!!!
|
|
|
|
Posts: 4053
Location: Land of the Musky | Made them with the same monster metal guides too so you can beat them all day long to get the ice off The guides are all no-ring guides.
4amuskie - 7/27/2016 8:53 AM
Tackle Industries - 7/26/2016 8:44 PM
Side note, I just made 50 TI 8' XH trolling rods. I made these 5 years ago but not too many.. Enough guys have asked me to make these again so I made 50. Sold 16 so far. I will not be putting these on my site. Normally they would be $165 MSRP +S/H but if anyone wants one they will be $150 with free S/H. I have the guys who wanted them taken care of now so on the chopping block they go
James
[email protected]
I have 2 of these and really like them. Great trolling rods for sure!!!!!!
|
|
|
|
Posts: 2687
Location: Hayward, WI | Those TI trolling rods make nice sucker rods too. |
|
|
|
Posts: 9
| I chose to grind out the rod holder instead of grinding the trigger on my rods. Looks factory and my rods are intact. |
|
|